Jessops 800-80 astronomical telescope manual
![jessops 800-80 astronomical telescope manual jessops 800-80 astronomical telescope manual](https://www.picclickimg.com/d/l400/pict/324885838526_/Jessops-TA800x80-astronomical-reflector-telescope.jpg)
Learning how to attach your camera to a telescope is one of the first steps needed to enter the world of astrophotography. If you lose sight of an object, just go back to a lower magnification, it will make it easier to find.ĭon't try and cram everything into one night - All the stuff that's up there has been around for some time and will be around for some time more.It’s a simple as this, if you want to take pictures through your telescope, you need to properly attach your camera to it. You can always swap the eyepieces in the scope for a higher magnification, but be gentle and don't go from the lowest magnification to the highest, you will very likely be disappointed with the results. Try to stick with the lowest magnification (highest number eyepiece ) until you get used to actually seeing in the scope the thing you want to point at. More magnification sounds better, but not always - with higher magnification, the more accurate you need to be with pointing the scope.
![jessops 800-80 astronomical telescope manual jessops 800-80 astronomical telescope manual](https://s3.amazonaws.com/images.fixya.net/fixya20/products/t/tasco/118x100/350x50mm_refractor_novice_telesco_4108.jpg)
Pat another thing to think about is the eyepiece magnification - the smaller the number, the greater the magnification. So you can see what is possible from the UK with a lot of patience. Preferably when its not full!!ġst 1/4 and last 1/4 are probably the best times as there is more detail on the edges. So when you are looking at the faint fuzzies (because that is all they are) that is what you will see normally only after your eyes have adapted!!Įnjoy looking at the moon though. Your eyes will take at least 30 mins to become dark adapted, so even looking at the moon will reset them The top one is from NASA and is probably about 100+ hours of data. Once you have aligned on both stars the scope is ready.įrom hte key pad you should be able to move the scope anywhere in the sky, and use its built in database.įay this is one of yours. Then center them in the main scope using the keypad press enter and the scope should goto the second star.
![jessops 800-80 astronomical telescope manual jessops 800-80 astronomical telescope manual](https://www.picclickimg.com/d/l400/pict/373792917975_/National-Geographic-50mm-Astronomical-Telescope-Tripod.jpg)
center these in the middle of the red dot finder first. Once this has finished it will select two alignment stars. Normally the scope will go through a start up routine where it measures is position and level ect. Once you have this set up you should be able to find things a lot easier.Īsuming you have the above scope, but most of them with goto should be the same. There are normally adjustment screws to assist you in this. Once you have the object in focus, you need to align the red dot finderscope so that the red dot that you can see is over the same object in your main scope. Or if you have a view across london, something the other side of london. The end of the garden is not far enough, something like the end of the street You need to align the red dot finder to your telescope, this normally only needs to be done once.įit the eyepiece to the telescope and focus on a distance object. You need to set the telescope up in daylight!!!!īuild it in your backgarden and put everything together, including the red dot finder. They normaly have a 26mm eyepiece to start with. What eyepieces did it come with? as it dosent say on the site. (Mike take your anti Meade pills now please ) I can only assume that you have purchased the Meade EXT90